Initial Operation; Device Placement; Connecting The Device To The Power Supply - HellermannTyton TT431 Manuel D'utilisation

Initial operation

5 Initial operation
The following tools are required for the start-up of the
device:
• PC or notebook with Windows Vista Server 2008
Windows 7 ® Server 2008
Windows 8.1 Server 2012
®
2016
®
Carry out the start-up in the prescribed sequence:
1. Place the device.
2. Install the drivers.
3. Connect the device.
4. Install the device in the operating system.
5. Install the TagPrint Pro software.

5 .1 Device placement

NOTE
Material damage caused by false environmental
conditions!
The device and the materials can be damaged by humidity
and dust.
f Setup the device only in dry places that are not exposed
to spray water or dust.
Proceed as follows:
1 Lift the device carefully out of the packaging.
2 Place the device on a level and stable surface.
3 Open the device cover.
4 Remove foam transportation safeguards from the area of
the printhead.
5 Check the device for transport damage.
6 Check the delivery for completeness:
• Thermal transfer printer
• Power cable
• USB cable
• Documentation
• CD with installation program, Windows drivers, and
operating instructions
Keep the original packaging for later transport.
If transport damage has been found or if the scope of
delivery was incomplete, please contact Customer Service at
HellermannTyton.
; The device has been setup correctly.
10
® ,
® , R2 Windows 8 ® Server 2012
, R2 Windows 10 Server
® ®
Operating Instructions • Thermal transfer printer TT431 • 10-2019 • 556-00400

5 .2 Connecting the device to the power supply

DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live
® ,
components.
f Only connect the device to a properly installed and
standardised socket with grounding.
f Check the voltage-level and current requirements.
f Do not touch any of the live components.
17
18
Device from the rear.
17 Power switch
18 Power connection jack
19 Slot for the SD card
20 2x USB master interfaces for key pad, scanner, USB memory device, bluetooth
adapter or service key
21 USB full-speed slave port
22 Ethernet 10/100 Base-T
23 RS-232 port
24 USB master interface for key pad, scanner, USB memory device, bluetooth adapter
or service key
The printer is equipped with a wide area power unit. The
device can be operated with a supply voltage of 230
V~/50 Hz or 115 V~/60 Hz without adjustment.
Proceed as follows:
1 Ensure that the device is switched off.
2 Plug the power cable into the power connection socket.
3 Plug the power cable into a grounded socket.
; The device is connected to the power supply.
19
20
21
24
22
23