Commissioning; Device Placement; Connecting The Device To The Power Supply - HellermannTyton TT4030 Manuel D'utilisation

Commissioning

5 Commissioning
The following tools are required for the start-up of the
device:
• PC or notebook with Windows XP
Carry out the start-up in the prescribed sequence:
1. Place the device.
2. Install the drivers.
3. Connect the device.
4. Install the device in the operating system.
5. Install the TagPrint Pro software.

5 .1 Device placement

NOTE
Material damage caused by false environmental
conditions!
The device and the materials can be damaged by humidity
and dust.
f Setup the device only in dry places that are not exposed
to spray water or dust.
Proceed as follows:
1 Lift the device carefully out of the packaging.
2 Place the device on a level and stable surface.
3 Open the device cover.
4 Remove foam transportation safeguards from the area of
the printhead.
5 Check the device for transport damage.
6 Check the delivery for completeness:
• Thermal transfer printer
• Power cable
• USB cable
• Documentation
• CD with installation program, Windows drivers, and
operating instructions
Keep the original packaging for later transport.
If transport damage has been found or if the scope of
delivery was incomplete, please contact Customer Service at
HellermannTyton.
; The device has been setup correctly.
10
® /Vista ® /7 ® /8 ®
Operating Instructions • Thermal Transfer Printer TT4030 • 06-2017 • 031-93478

5 .2 Connecting the device to the power supply

DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live
components.
f Only connect the device to a properly installed and
standardised socket with grounding.
f Check the voltage-level and current requirements.
f Do not touch any of the live components.
22
23
Device from the rear.
22 Power switch
23 Power connection jack
24 Slot for the SD card
25 2x USB master interfaces for key pad, scanner, USB memory device, bluetooth
adapter or service key
26 USB full-speed slave port
27 Ethernet 10/100 Base-T
28 RS-232 port
29 USB master interface for key pad, scanner, USB memory device, bluetooth
adapter or service key
The printer is equipped with a wide area power unit. The
device can be operated with a supply voltage of 230
V~/50 Hz or 115 V~/60 Hz without adjustment.
Proceed as follows:
1 Ensure that the device is switched off.
2 Plug the power cable into the power connection socket.
3 Plug the power cable into a grounded socket.
; The device is connected to the power supply.
24
25
26
29
27
28