Concept CPT273 Manuel D'utilisateur page 5

sPeCiFiCATioNs
Your CPT273C Air ComPressor:
= Oil-free belt drive
= 1.65 litre (3/8 gal.) tank
= 1.5 HP, 120V, 60Hz
= 3300 RPM
= 3.2 cfm @ 40 psi
= 2.0 cfm @ 90 psi
= Maximum pressure: 125 psi
= Air line regulator & gauge- set your exact line pressure
= Includes: 1 x brass 1/4 NPT female threaded quick-connect air coupler
1 x brass 1/4 NPT male threaded quick-connect air coupler
2 x brass 1/4 NPT male threaded quick-connect air plugs
1 x brass 1/4 NPT female threaded quick-connect air plug
1 x 1/4 NPT threaded brass air tire chuck
1 x 1/4 NPT female threaded chrome-plated air blow gun
w/ 1/8 NPT nozzle thread
2 x chrome-plated 1/8 NPT threaded ball-inflation needles
1 x tapered 1/8 NPT threaded brass inflation nozzle
1 x 1/8 NPT threaded brass nozzle insert
5 mm chrome-plated hex wrench
1 x pipe thread sealant tape
= Tool weight: 6.8 kg (15 lb.)
A tool with a higher air demand than this compressor can produce may either not
function, or not function well. It may also cause the compressor to run without
stopping for long periods of time, trying to maintain pressure in the tank. This
can cause either the motor or compressor pump to overheat and damage them.
Be sure the requirements of your tools can be met by the compressor.
To compress air, the piston in the pump moves up and down in the cylinder.
On the down stroke, air is drawn in through the inlet valve. Since the
discharge valve remains closed, as the piston goes up, the air in the cylinder is
compressed. The inlet valve closes and compressed air is forced out into the air
receiver. A check valve prevents it from going back into the pump. Working air
is not immediately available. The pump continues to add air until the air receiver
pressure builds to above that required at the regulator.
Your CPT273N 2" BrAd NAiler
= Shoots industry standard 18 gauge brad nails in the following sizes:
15mm (5/8"), 20mm (3/4"), 25mm (1"), 30mm (1-3/16"), 35mm (1-3/8"),
40mm (1-9/16"), 45mm (1-3/4"), and 50mm (2") such as Superior Fasteners
BN1800 series; as well as Bostitch BT1300 series, Duofast 4400,
Haubold 12/, Porter-Cable BN18000 series, Prebena J-series, and
Senco AX.
= Air consumption is 2 – 4 cfm (57 – 113 litres/min) @ 60 to 90 psi
(414 – 621 kPa).
= Quick-release nose piece.
= Padded hand grip.
= Adjustable exhaust deflector
= Weight: 1.5 kg (3.3 lb)
25' loNG X 3/8"i.d. PVC Hose
(7,6 m x 9,5 mm)
5