Concept CPT273 Manuel D'utilisateur page 3

14. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING
15. DO NOT USE THE COMPRESSOR IF IT CANNOT BE SWITCHED ON OR
16. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY AD-
1. COMPRESSED AIR FROM THIS UNIT MAY CONTAIN CARBON
2. AIR ONLY: Use this compressor for compressing air only. Do not compress
3. BREATHING PROTECTION: Always use a respirator when spraying paint
4. MAINTAIN TOOLS WITH CARE. Keep tools clean for better and safer
5. NEVER USE THIS EQUIPMENT if it is leaking air; has missing or damaged
!
6. DO NOT USE THE AIR HOSE to move the compressor. Release the pres-
7. DO NOT ATTEMPT ANY MAINTENANCE OR ADJUSTMENT with the
8. CHECK FOR DAMAGED PARTS. Make frequent inspections for the correct
9. REPLACEMENT PARTS When servicing, use only identical Superior re-
10. EMPLOYERS MUST ENFORCE COMPLIANCE with the safety warnings
sAFeTY PreCAuTioNs sPeCiFiC To ComPressor ComPoNeNTs
1. TANK SAFETY VALVE: This valve prevents damage to the air receiver if
2. PRESSURE SWITCH: The air pressure switch is factory pre-set for optimum
3. MOTOR AND COMPRESSOR PUMP: Air compressors get hot during
!
4. AIR TANK: Over-pressurizing the air receiver, piping, or tank could cause
5. TAMPERING: If any of the components above are found to have been
imPorTANT sAFeTY iNsTruCTioNs
KEYS OR WRENCHES before turning the tool on. Left attached, these parts
can fly off a rotating part and result in personal injury.
OFF. Have it repaired before using it.
JUSTMENTS. Changing attachments or accessories can be dangerous if
the tool could accidentally start.
ComPressed Air CAuTioNs
MONOXIDE. The air produced is neither suitable for breathing nor food pro-
cessing without filtering and testing to all applicable legal standards.
other gases.
or chemicals.
performance. Follow instructions for lubricating and changing accessories.
Keep dry, clean and free from oil and grease.
parts, guards, or shields; or requires repair. Make sure all screws and caps
are securely tightened.
sure in the storage tank before moving.
compressor in operation, the power connected, or air under pressure in the
system.
functioning of components and safety mechanisms.
placement parts and fasteners recommended by us.
and all other instructions in this manual. Keep it available for use by every-
one assigned to use this equipment.
a malfunction in the compressor pump occurs. It is factory pre-set at a limit
specific to your particular model and adjustment. Do not tamper with it. This
will automatically void your warranty.
performance. Do not bypass or remove this switch. Serious damage to
equipment or personal injury could result from too high an air pressure.
operation. Do not touch the motor, discharge tubing, or compressor while it
is running. The compressor turns itself on automatically while the power is
connected.
it to explode or burst. To protect from over-pressurizing, the compressor is
equipped with a factory pre-set safety valve. Do not remove, make adjust-
ments to or substitutions for this valve. Perform a test of the valve from time
to time: pull the ring on the valve to make sure that it operates freely. If the
valve does not operate freely, replace it before further use. Never weld to,
drill into, or change the air receiver in any way.
changed or tampered with, the warranty will be made void. When servic-
ing, we recommend using only identical Superior replacement parts and any
replacement parts used must have the same specification as the original
equipment.
3