Setting Channels - KERN EOB_F Mode D'emploi

Setting channels

(display unit)
+
(platform)
22
The balance has the possibility to set different channels. This
is particularly necessary if several platforms are inserted next
to each other. In this case failures may appear if not different
channels have been set. It is possible to select between 3
channels.
Setting channels on the display unit:
Set rocker switch next to the platform to „1".
Switch-on display unit using ON/OFF button and wait for zero
display. The data receiving symbol
The triangle displays the selected channel.
If the data receiving symbol
button to change to the correct channel
Setting the channels on the platform:
Switch-off platform (rocker switch on the side to „0")
Actuate the dip switch at the lower side of the platform. (pin 4
is not used).
Platform 314,5 x 304, 5 mm:
Platform 550 x 550 mm:
flashes
does not appear, use the CH1-3
EOB_F-BA-e-1611