Display Messages - Saeco Incanto Mode D'emploi

36

DISPLAY MESSAGES

Messages are displayed to guide users and help them to use the machine correctly.
Press "MENU/OK"
ENERGY SAVING
Descale the machine
DESCALING
READY FOR USE
Fill the water tank with fresh drinking water.
FILL WATERTANK
Fill the coffee bean container and start the coffee
dispensing cycle.
COFFEE BEANS EMPTY
Open the door, remove the dregs drawer and empty the
used coffee grinds into a suitable container.
DREGDRAWER FULL
Important note: the dregs drawer may be emptied only when the machine
is on. The drawer must be removed for at least 5 seconds. If you empty the
drawer with the machine off, you will not be able to dispense coffee the next
time you switch the machine on.
Fit the brew unit properly in place.
BREWUNIT MISSING
Fit the drip tray and dregs drawer properly in place.
DREGDRAWER MISSING
Close the front door.
CLOSE DOOR
Load the circuit (Starting up)
VENTILATE
BREWUNIT BLOCKED
Contact an authorised service centre.
GRINDER BLOCKED
PROBLEMS CAUSES
The machine does not The machine
turn on. connected to the power
supply.
The coffee is not hot The cups are cold.
enough.
A low temperature has
been set.
Only water is No preground coffee has
dispensed when you been introduced.
select "preground
coffee".
No hot water or steam The tube
is dispensed. clogged.
The machine takes a Excessive
long time to warm up. built up.
The brew unit cannot The unit has stopped in
be removed. the wrong position.
REMEDIES
is not Move the main switch to ON.
Check the plug and the
connection
Warm up the cups.
Set the machine on a higher
temperature.
Dispense again
introducing preground coffee.
nozzle is Clean the nozzle opening
with a needle.
During this
ration, the knob must
be closed and the machine
must be off.
scale has Descale the machine.
Close the door and switch on
the machine; the brew unit
will move back into position.
after
ope-