VOLTCRAFT CT-1500Pb Notice D'emploi page 40

The language setting and the contrast are saved even if the device was turned off in
between.
Now, connect the accumulator terminals with the correct polarity.
Connect the red terminal with the positive terminal and the black terminal with the
negative terminal of the accumulator.
If you have short-circuited the two terminals, the following message will be displayed
"AUTO DETECTION
"- SHORT CIRCUIT
The false connection of the accumulator will be signalised by the message
"AUTO DETECTION
"- CHECK POLARITY
Now, the nominal capacity indicated on the accumulator has to be set. You can set
it in the range of between 10Ah and 200Ah by pressing the UP and DOWN keys.
Confirm all your entries with OK. You can cancel a wrong entry by pressing ESC. The
capacity is reset to 10Ah and can then be reentered.
Please note that warranty will lapse if you select a false capacity. Any claim to war-
ranty will lapse in such a case for the charging station (and of course for the accu-
mulator).
To give you an immediate general idea about the state of the accumulator, the cur-
rent charge status of the accumulator is displayed in percent. This value is only reli-
able, if the accumulator has not been previously charged or discharged for at least
one hour.
"CAPACITY 68%
" 10Ah
First you enter the capacity from 10 to 200 Ah in 10Ah steps.
"CAPACITY 68%
" 10Ah
" 200Ah
With an accumulator capacity of less than 200Ah, you can afterwards set the single-
digits from 1Ah to 9Ah.
40
"
"
"
"
"
"
"
"
"