Cleaning Of The Turbo Steam Nozzle; Cleaning Of The Automatic Cappuccino Maker - La Pavoni PCN Mode D'emploi

English
A
B
C
D
E
Picture 1
12.1 – CLEANING OF THE TURBO STEAM NOZZLE
Always clean properly with a wet cloth the end of the turbo steam nozzle (6) after use to avoid its obstruction
and altering of the beverages flavour. Once every now and then clean it more specifically (picture 1):
•
Remove the spout cover (E) pulling it downwards.
•
Unscrew the threaded nut (A) turning it anticlockwise until the steam nozzle comes out (8).
•
Clean the injector (D) in warm water to get rid of possible milk rests and clean with a needle the hole
of the steam nozzle.
After cleaning please assemble it as follows:
•
Insert the threaded nut (A), the gummy rings (B) and (C) on the steam nozzle (8), insert the injector
(D) and screw the threaded nut (A) clockwise in order to fix the injector.
•
Insert the nozzle cover (E) pushing it upwards.
12.2 – CLEANING OF THE AUTOMATIC CAPPUCCINO MAKER
Apart from cleaning it every time it has been used, please clean it every now and again more accurately
(picture 2):
•
Remove the silicone tube (B) from the suction tap (D).
•
Unscrew the threaded nut (A) turning it anticlockwise until the steam nozzle comes out (8).
•
Remove the part (F) pressing on its milled sides from the main frothing unit (E).
•
Remove the suction tap (D) from the main frothing unit (E).
•
Remove the regulation knob (C) from the suction tap (D).
Rinse everything thoroughly with warm water to remove possible milk rests and reassemble the automatic
cappuccino maker again.
BUONDI_PUCCINO_2010.indd 48
8
48
Picture 2
15/01/10 15.39