Error Messages And Diagnostics - Pilz PSEN op2H Manuel D'utilisation

PSEN op2H Series

7.2. Error messages and diagnostics

The LEDs that display the function can also be used to show operators
the main causes of a device failure or defect.
RECEIVER:
Fault
Check the output connections.
- If a capacitive load > 0.1µF is generated, contact PILZ
customer services.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Check the alignment of both devices.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Switch the device off and then on again; ensure that the TEST
input is connected to the supply voltage via a button via a N/C
contact.
- Power supply failure. Check the connections, check that the
supply voltage value is correct.
Transmitter:
Fault
- Transmitter is not working. Check the connections, check that
the supply voltage value is correct.
- If the fault continues, contact PILZ customer services.
- Power supply failure. Check the connections, check that
the supply voltage value is correct.
Instruction Manual
Checks/remedy
Checks/ remedy
28