Start Mode - Pilz PSEN op2H Manuel D'utilisation

Operating Manual

6. START MODE

If the beams between the receiver and transmitter are interrupted by
an opaque object, the OSSD outputs will switch and the safety
contacts will open ("BREAK" operating status).
There are two different ways to restart normal ESPE mode (close
safety contacts, "SAFE" operating status), depending on the device
model:
•
Automatic START: After the protected field has been interrupted,
the ESPE returns to normal mode as soon as the detected object
has been removed from the protected field.
TIMING DIAGRAM FOR THE RESET FUNCTION
25
PSEN op2H Series