Starting Work; Setting The Position Of The Rear Bar - breviglieri MekFarmer 120 Manuel D'utilisation Et D'entretien

MekFarmer 120
4
FIG. 34

5.6.10 STARTING WORK

DANGER
Before starting the machine, make sure that the safety
devices are in perfect condition.
Never start the machine if there is a suspected mecha-
nical failure. Contact the technical assistance centre.
Before starting work, get familiar with the control devi-
ces and their functions.
soil and check for any possible excessive slopes. Make
sure that there are no objects in the area that could
be picked up and thrown at a distance. Clear the area
of these objects. Check constantly that there are no
people, children or pets in the working range of the
machine.
Check the rpm rate before engaging the power take-off.
Do not switch the 540 rpm rate with the 1000 rpm one.
It is absolutely forbidden to linger within the range of
action of the machine when this is operating.
It is absolutely forbidden to get between the tractor and
machine while the engine is running and the driveline
engaged.
Never engage PTO when the tractor engine is off. Dan-
ger of sudden movements when restarting the tractor.
The operator must never leave the driver's seat when
the tractor engine is on and/or the machine is running.
Disengage PTO when the machine is not used.
1
2
3
The speed of the tractor when the machine is opera-
tion must not exceed 3-4 mph or components could be
broken or damaged.
Always disengage PTO when lifting the machine to pre-
vent the PTO shaft working at a too big angle (see PTO
shaft instruction manual).
Lift the machine from the ground when working in
curve or in reverse.
5.6.11 SETTING THE POSITION OF THE REAR
Park the machine on a horizontal and stable surface.
Disengage PTO. Turn the tractor off. Put the parking
brake on.
Danger of breakage. Never lower the rear bar more
than the length of the blades. The rear bar must never
touch the ground.
-
CAUTION
BAR
DANGER
CAUTION
-
-
49