Hornbach C800 Manuel D'installation Et De L'utilisateur page 207

Hang the garage door opener
Bend the hanging brackets to
bridge the distance between
the garage door opener and the
ceiling.
Mark the fastening holes and
drill the holes. Fix the bracket
with appropriate plugs and
screws.
Attach the rail to the hanging
brackets with the U rail.
Remove the batten from the
garage door.
Door reinforcement
CAUTION
Fiberglass, aluminum or light-
weight steel garage doors
require reinforcement before
installation of door bracket.
You might enforce your door
with U-shaped braces on your
own risk. The horizontal re-
inforcement should at least be
long enough to be secured to
two vertical supports. The verti-
cal reinforcement should cover
the height of the top panel.
14
WARNING
To prevent possible serious injury or death:
• Select an installation location without pipes or cables behind it.
• Bracket must be rigidly fastened to structural support on ceiling,
otherwise garage door might not reverse when required. Do not
install bracket over drywall.
• Concrete anchors must be used if mounting bracket or structural
support into masonry.
2x 2x
2x
2x
15
ENGLISH | 207