Safety Reversal System Test - Hornbach C800 Manuel D'installation Et De L'utilisateur

Pairing controls
LED indicator 1
Button 1 2
Button 2 3
Activating button 4
Press the Code button until the
LED 1 shines continuously.
Within 10 seconds, press button
1 or 2 of the remote control, or
the activating button of the wall
control.
Press the same button again.
LED 1 will fl ash and turn off .
Repeat steps 1. to 3. to code
up to a maximum of 10 remote
controls.

Safety reversal system test

With the door fully open, place
a board with a thickness of 5 cm
centered in the way of the door.
Press remote control push but-
ton. When closing, the door
MUST reverse when making
contact with the board.
Otherwise do not use the
garage door opener any more;
instead seek professional assis-
tance for repair.
212 | ENGLISH
3
Remote control
2
1.
1.
2.
3.
WARNING
Without a properly installed safety reversal system, persons (particu-
larly small children) could be seriously injured or even killed by a clos-
ing garage door. Incorrect adjustment of garage door travel limits will
interfere with the proper operation of the safety reversal system.
• The safety reversal system MUST be tested at least once every
month.
• The safety reversal system must be tested after any adjustments
made.
1.
2. 1.
Wall control
1
3
2.
< 10 sec.
2.
4
< 10 sec.