Checklist - Murray 620000x30C Manuel De L'utilisateur

TO ASSEMBLE
THE LOWER CHUTE
For shipping purposes, some models are
shipped with the rear nut and bolt removed
from the lower chute. If the lower chute is
not attached, assemble as follows:
1. Use the bolt and nut found in the parts
Lower
Chute
Bolt

CHECKLIST

n
Before you operate your new snow thrower,
to ensure that you receive the best perfor-
mance and satisfaction from this quality
product, please review the following check-
list:
n All assembly instructions have been
completed.
n The discharge chute rotates freely.
n No remaining loose parts in carton.
F–011013M
ASSEMBLY
bag ato attach the lower chute.
2. Tip the lower chute backward until the
hole in the chute ring is aligned with the
hole in the lower chute. (see Figure 3).
3. Attach the lower chute with bolt and
nut. Make sure the nut is tight.
While learning how to use your snow throw-
er, pay extra attention to the following impor-
tant items:
n Use a U.L. listed two conductor exten-
sion cord suitable for outdoor use in cold
weather.
n Become familiar with all controls–their
location and function. Operate controls
before starting motor.
9
Nut
Figure 3