Murray 620000x30C Manuel De L'utilisateur page 11

TO USE AUGER PROPEL ACTION
1. Squeeze the control switch lever down
against the upper handle to allow the au-
ger to turn.
Normal Operating Position
Auger Propelled
Position
TO START SNOW THROWER
IMPORTANT: Use a U.L. listed two conduc-
tor extension cord suitable for outdoor use
in cold weather. Extension cord should be
no longer than 100 feet.
RECOMMENDED EXTENSION CORDS
MINIMUM GAGE FOR CORDS SETS
Volts Length of Cord in Feet
120V 25ft.
Ampere
rating not
more more
than than AWG
0 6 18
6 10 18
10 12 16
12 13 14
Always connect extension cord to control
switch on snow thrower first, then connect the
other end to a wall receptacle installed in ac-
cordance with local codes and inspection au-
thorities.
F–011013M
OPERATION
2. To propel forward, raise the handle to al-
motor temporarily if the snow thrower is
overworked, and will automatically reset
as the motor cools. If the motor stops,
release the control bar, disconnect the
Propel
extension cord and allow the motor to
Forward
cool five minutes before continuing op-
eration.
Figure 6
To start snow thrower operation, proceed as
follows:
1. To prevent accidental disconnection of
2. Snap strain relief clip down over loop of
50ft. 100ft.
16 16
16 14
16 14
12 10
3. To operate snow thrower turn key (clock-
11
low the auger blades to contact the
ground (See Figure 6).
WARNING: The motor is
equipped with a protector that
will disconnect power to the
extension cord from control switch during
operation, loop extension cord through
strain relief clip on control switch (see
Figure 7).
extension cord (see Figure 7). Connect
extension cord to power plug on control
switch.
Strain Relief
Clip
wise) and hold in UNLOCKED position
while pulling control switch lever toward
Power Plug
Extension Cord
Figure 7