Laserworld Ecoline Série Mode D'emploi page 9

8.3. Music mode, Sound-to-light operation
Your device runs in music mode:
The laser effects are triggered by sound. Turn the sensitivity pot in the clockwise
direction to increase sound sensitivity, turn the pot in the counter-clockwise
direction to decrease sensitivity. The laser effect will automatically turn off after 5
seconds without music input.
8.4. Master-Slave-Mode (Slav)
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors
of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Select auto or music mode
at the master projector
(see above)
8.5. DMX-512 mode
Connect a DMX controller to operate the laser. The laser uses 7 DMX channels,
so make sure that the next device uses an address that doesn't overlap with this
range.
Channel Value
1 0 -49
50 - 99
100 - 199
200 - 249
250-255
2 0 - 255
DMX cable
To use this mode, please press the
MODE button until the display shows
SLAV and confirm by pressing Enter.
Function
Laser off
Automatic mode
Automatic mode - slow
Sound-to-light
DMX active
Red intensity
Slave projector