REICH easydriver basic 1.8 Instructions D'assemblage Et Mode D'emploi page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Installation, mechanics
M6
Fastening the clamping plates,
Figures 4.2 to 4.4
Fasten the clamping attachments of the right and left
drive unit with 60 Nm.
Ensure that the distance between the drive rollers and
the tyres has not changed and is still 15-20 mm (Figure
9.2).
Attach the clamping shoes included in the delivery
scope behind the left and right clamping attachment
(Figure 4.3).
Fasten the clamping shoes by tightening the appropri-
ate M10x30mm screws with 60 Nm (Figure 4.4).
The clamping shoes provide additional safety by pre-
venting the drive unit from sliding on the vehicle frame.
M7
Installation of stabiliser rods, Figure. 5 to 6
Pull the small shrink sleeve onto the end (without hole)
of the small synchronisation rod. It is used to dampen
the noise.
Slide the telescopic synchronisation rods into each
other (Figure 6). The attachment holes must be on the
outside. Fasten the holder to support the synchronisa-
tion rod, preferably at the centre of the stabiliser
(Figure 6).
Push the synchronisation rod through the holder and
fasten the small rod with the screw and nut provided to
the spindle (Figure 5). Slide the second shrink sleeve
onto the large rod at the level of the holder and fasten it
to the other spindle.
M8
Control
Please check at the end of the process that all screws
have been fasted and that no part was forgotten!
GB5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Easydriver basic 2.3

Table des Matières