General Information; Safety Instructions - REICH easydriver basic 1.8 Instructions D'assemblage Et Mode D'emploi

2. General information

It is essential to read these instructions carefully
before installation and operation and to store them
in the vehicle ready for use!
The installer is responsible for proper and appropriate
installation. The installation should preferably be per-
formed by trained, specialised staff. It can be performed
in front of or behind the axle. Parts of the chassis, axle
suspensions or breaking facility may under no circum-
stances be removed, changed or affected. Appropriate
operation can only be ensured after correct installation,
with correct tyre pressure and the correct distance
between drive rollers and tyres.
Reich GmbH does not accept liability for damage of any
kind resulting from the installation or operation of the
easydriver with a caravan or trailer.
We will exclusively and at most refund the full pur-
chasing costs for the easydriver in the event of damage
caused by a fault in the device.
We reserve the right to change the easydriver at any
time without prior announcement.
The easydriver is a manoeuvring aid for caravans and
other trailers to be used at camp sites and on private
land.
Sales in the USA and Canada as well as operation in
these countries are prohibited.
Reich GmbH reserves all rights. This installation and
operating instructions and their content may not be
reproduced by printing, photocopying, on microfilm or
in any other electronic or mechanical way without the
prior written approval of Reich GmbH.
GB2

3. Safety instructions

3. Safety instructions

Check whether the drive rollers are in contact with
the tyres before manoeuvring (see Figure 3.2 = ON).
The manoeuvring process may only be performed in
this position.

Practice handling the remote control and its functions
in open terrain when using the easydriver for the first
time.

The installation of an easydriver usually reduces the
ground clearance. Please consider the reduced ground
clearance when driving and manoeuvring (80 mm
minimum ground clearance - 120 mm recom-
mended).

Check whether the drive rollers are in the rear posi-
tion before driving off (see Figure 3.1 = OFF).

Secure the vehicle before swivelling off the
drive rollers!

The caravan/trailer may only be moved by the towing
vehicle when the manoeuvring drive has been swiv-
elled off (Figure 3.1 = OFF).

You may not operate the easydriver if it is faulty!
Have the device inspected by an authorised, special-
ised workshop.

The battery must be disconnected and protected
against reconnection before any installation, mainte-
nance or assembly work takes place. Working with
live voltage poses a mortal danger.

Batteries must be handled, stored and disposed of
according to the manufacturer's instructions. Used-up
batteries must be recycled. Risk of acid burns: Battery
acid is very corrosive. Keep children away from acid
and batteries. Check the battery for firm attachment.
Adhere to the instructions on the battery and regu-
larly check it. Exchanging or charging must be per-
formed with great care.

The technical data (last page of the operat-
ing instructions) such as climbing ability and
total weight of the caravan may under no
circumstances be exceeded..
Note:
We will not accept liability for damage caused by not
adhering to these instructions. Changes and errors
expected.