Installation Situation - REICH easydriver basic 1.8 Instructions D'assemblage Et Mode D'emploi

Please take note:

Loosen the parking brake of the caravan/trailer
before starting to manoeuvre (position of the drive
rollers see Figure 3.2 = ON) with the manoeuvring
drive. Re-tighten the parking brake after manoeuvring
and only then swivel off the driving rollers (Figure 3.1
= OFF).

T he easydriver does not replace the parking
brake!

P ersons (in particular children) may not remain in the
caravan/trailer or within its manoeuvring range dur-
ing operation.

Never allow children to play with the easydriver.

The easydriver may only be operated by adults.

Do not stay near the drive rollers during operation.

Consider the operating range of the remote control
(approx. 10 m).

The tyres of the caravan must be of the same type.

The tyre pressure must correspond to the pressure
specified in the operating instructions of the caravan/
trailer.

Point the towbar downwards where possible when
manoeuvring on inclines.

Never use the easydriver when the caravan/trailer is
still connected to a towing vehicle.

Observe the caravan/trainer and its proximity during
the manoeuvring process.

The total weight and the payload of the caravan/
trainer are affected by the easydriver.

Do not use the easydriver as a jack support.

Remove sharp stones from the tyres before using the
easydriver.

4. Installation situation

Floor caravan
L-profile U-profile
The chassis frames of caravans and trailers are classi-
fied into L- and U-profiles. They require different,
additional fastening sets, depending on the vehicle and
the installation conditions. These fastening sets are
optionally available. Check the installation dimensions
of your easydriver in Figure 8.1.
Parts of the chassis, axle suspensions or braking facility
may under no circumstances be removed, changed or
affected.
In Germany, all changes to the chassis
require approval by a motor vehicle expert!
GB3