Using The Vegetable Cutting Adapter - gourmetmaxx AMG31B-100 Mode D'emploi

the AUS (Off) position fi rst and wait until the motor has come to a full stop
before moving the button to the RÜCKWÄRTS (reverse) position.
9. After use, turn the device off by setting the RÜCKWÄRTS / AUS / AN (Rever-
se / Off / On) button to the AUS (OFF) position.
10. Disconnect the mains plug from the socket after use.
11. Cut the hollow section into pieces approximately 8 cm in size.
12. Push the pieces together on one side and add a small amount of the prepared,
cooled fi lling to the dough pocket. Then close the other side of the dough pocket.
13. Then fry the fi lled dough pockets in hot oil until they are golden brown.
14. Clean the device and accessories after every use as described in the chapter
"Cleaning and storage".

Using the vegetable cutting adapter

1. Place the motor base on a stable, level surface.
2. Place the vegetable slicer adapter in the receptacle on the motor base. Place the
vegetable cutting adapter on the motor base so that the fi ll chute is tilted to the right
(that is, towards the RÜCKWÄRTS / AUS / AN (Reverse / Off / On) button).
3. Turn the vegetable cutting adapter to the left until it is in a perpendicular position and
locks into place.
10. If the device jams while in operation, set the RÜCKWÄRTS / AUS / AN (Rever-
se / Off / On) button to the RÜCKWÄRTS (reverse operation) position to remove food
that is causing the conveyor spiral to jam. ATTENTION Risk of injury! Never reach
into the fi ll chute or the blade head to remove food while the device is connected to
the power supply! Always switch off the device and disconnect the mains plug from
the socket before taking the device apart!
Never set the RÜCKWÄRTS / AUS / AN (Reverse / Off / On) button to the
RÜCKWÄRTS (reverse) position during operation. Always set the button to
the AUS (Off) position fi rst and wait until the motor has come to a full stop
before moving the button to the RÜCKWÄRTS (reverse) position.
08612_DE-GB-FR-NL_V3.indb 28 08612_DE-GB-FR-NL_V3.indb 28
4. Insert a vegetable cutting attachment (grater or slicer) of
your choice.
5. Connect the device to a properly installed socket with pro-
tective earth contacts.
6. Fix the vegetable cutting attachment in place with the fi -
xing nut for the vegetable cutting adapter.
7. Place a bowl under the vegetable cutting adapter to coll-
ect the minced food.
8. Turn the device on by setting the RÜCKWÄRTS / AUS / AN
(Reverse / Off / On) button to the AN (On) position.
9. Add the foods you want to mince in the fi ll chute. Use the
plunger to gradually push the food through the fi ll chute.
ATTENTION Risk of injury! Never use your hand or ob-
jects other than the enclosed plunger to push foods into
the fi ll chute!
28
04.11.2014 12:06:09 04.11.2014 12:06:09