Hendi 970294 Mode D'emploi page 6

Preparations before using for the first time
• Check to make sure no parts are missing. If any
parts are missing, contact your supplier.
• Remove all the packing material.
• Check the appliance for completeness and trans-
port damages. In case of incomplete delivery or
damage, contact supplier immediately. DO NOT
use the appliance. (See ==> Warranty).
• Clean the blade. Be careful: the blade is very
sharp. (Use gloves if necessary, not included)
1. Top view of the appliance
EN NL
NOTE! The sharpening device is equipped with a safety switch. If the sharpening device is not properly at-
tached, you will not be able to use the appliance.
• Attach the hand guard.
1. Place both screws in
the carriage.
NOTE! You are advised not to use the appliance if the hand guard is not attached as instructed! These are
safety features that will prevent possible injury. If you do not attach these features, there will be a risk of
injury.
6
2. Attach the sharpening module
in such a way that the blade
does not move between the
wheels.
2. Attach the hand
guard.
• Keep open a space of at least 10 cm around the
appliance to allow for adequate ventilation.
• Position the appliance in such a way that the plug
is always accessible.
• If the sharpening device is not attached, proceed
as follows:
3. Secure the sharpening device
to the machine by tightening
the holder. Check to make
sure that the sharpening de-
vice is well secured before us-
ing the machine.
3. Place the two wash-
ers over the white
bolts.
4. Screw on the two
dome nuts.