Troubleshooting - ARTHUR MARTIN ASL5341LA Notice D'utilisation

16
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
• To maintain the performance of your
appliance at its best, we recommend to

TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
WARNING! Repairs not
properly done may result in
serious risk to the safety of the
user. Any repairs must be
performed by qualified
personnel.
Problem and alarm code
You cannot activate the ap-
pliance.
The program does not start.
The appliance does not fill
with water.
The display shows
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
Possible cause and solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end
of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clogged.
• Make sure that the interior filter system is not clogged.
.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service Cen-
tre.
.
use monthly a specific cleaning product
for dishwashers. Follow carefully the
instructions on the packaging of the
product.
With some problems, the display
shows an alarm code.
The majority of problems that can
occur can be solved without the need
to contact an Authorised Service
Centre.