ARTHUR MARTIN ASL5341LA Notice D'utilisation page 18

18
Problem
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
The interior of the appliance is
wet.
Unusual foam during washing.
Traces of rust on cutlery.
There are residues of detergent
in the dispenser at the end of
the programme.
Odours inside the appliance.
Possible cause and solution
• Tableware has been left for too long inside a closed appli-
ance.
• There is no rinse aid or the dosage of rinse aid is not
enough. Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• For the best drying performance activate the option Xtra-
Dry.
• We recommend to always use rinse aid, even in combina-
tion with multi-tablets.
• The release quantity of rinse aid is too much. Adjust the
rinse aid level to a lower level.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Adjust
the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• For the best drying performance activate the option Xtra-
Dry.
• The programme does not have a drying phase or has a
drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a dif-
ferent brand or activate the rinse aid dispenser and use
rinse aid and multi-tablets together.
• Keep the dishwasher door ajar for some time before re-
moving tableware.
• This is not a defect of the appliance. it is caused by the
humidity in the air that condenses on the walls.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an Au-
thorised Service Centre.
• There is too much salt in the water used for washing. Re-
fer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Avoid to put silver and stainless steel items close together.
• The detergent tablet got stuck in the dispenser and there-
fore was not completely washed away by water.
• Water cannot wash away the detergent from the dispens-
er. Make sure that the spray arm is not blocked or clog-
ged.
• Make sure that items in the baskets do not impede the lid
of the detergent dispenser from opening.
• Refer to "Internal cleaning".