Internal Cleaning; Cleaning The Spray Arms; External Cleaning; Troubleshooting - ARTHUR MARTIN ASL5346LA Mode D'emploi

16
CAUTION! An incorrect position
of the filters can cause bad
washing results and damage to
the appliance.

Cleaning the spray arms

Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.

TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
WARNING! Repairs not
properly done may result in
serious risk to the safety of the
user. Any repairs must be
performed by qualified
personnel.
Problem and alarm code
You cannot activate the ap-
pliance.
The program does not start.

Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
damp cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
• To maintain the performance of your
appliance at its best, we recommend to
use monthly a specific cleaning product
for dishwashers. Follow carefully the
instructions on the packaging of the
product.
With some problems, the display
shows an alarm code.
The majority of problems that can
occur can be solved without the need
to contact an Authorised Service
Centre.
Possible cause and solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end
of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.