AYA ACA175WA Instructions D'utilisation page 22

Congélateurs 1 porte
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

be frozen should be placed in the drawer in contact with the drawer surface as far as
possible and spaced apart to allow cold air to circulate between them. They should not
touch existing packets.
If there is enough room, transfer the food you have frozen to the baskets or drawers to
allow you to freeze a further load in the top drawer. No harm will result if you forget to turn
off the fast freeze switch after 24 hours, but by reason of economy, try to remember to
turn it off when freezing is complete. Exceptionally large items can be stored by removing
the upper basket. Frozen food should not be refrozen once it has thawed out. Do not
remove items from the freezer if your hands are damp/wet, as this could cause skin
abrasions or "frost/freezer burns".
For safety reasons, the freezer baskets are fitted with stops but are readily removed by
pulling them forward to the stop, then lifting the front and pulling all the way out. Refit by
reversing this procedure.
Frozen food storage
Pre-packed commercially frozen food should be stored in accordance with the
manufacturer's instructions for a 4 star frozen food compartment and should be put in the
freezer as soon as possible after purchase. Your freezer provides for long term storage
which generally means up to 3 months but the length of the time can vary and it is
important to follow the recommended times shown on packets of commercially frozen
food. Do not place sealed containers or carbonated liquids such as fizzy drinks into the
freezer as it creates pressure on the container which may cause it to explode leading to
damage to the freezer. Ice cubes and ice lollies should not be consumed immediately
after removal from the freezer as it may result in low temperature skin abrasions.
Door reversal
The side at which the door opens can be changed, if the installation site requires. Tilt the
appliance slightly towards the rear and prop it securely. Unscrew the door hinge screws
and remove the hinge pin bracket. Open the door a little way and take it out downwards.
Unscrew the upper pin and screw it into place on the opposite side. Fit the door into the
upper pin and close it. Screw the hinge pin bracket securely into place on the opposite
side using the screws.
21

Publicité

Table des Matières
loading

Table des Matières