Aqua Medic DC Runner 1.2 Mode D'emploi page 7

0 - 10 V: The pumps must be operated with at least 60% power, otherwise damage will occur. Short pulse rates
are not possible due to the start-up delay on the pumps.
Press the FEED button until 4 LEDs (Fig. 4, No. 2) light up in the middle to activate the 0 - 10 V socket. In the
same way, the 0 - 10 V output can be deactivated again.
Fig. 4: DC Runner Controller
1. Feed button
2. LEDs
By keeping the minus and FEED buttons pressed and hold until the LEDs flash once, the keyboard of the
controller can be locked or unlocked.
5. Maintenance / Cleaning
From time to time, the pump needs to be cleaned. For cleaning, do the following:
plate. Then, turn the basket and take it off the pump. Now, the complete impeller can be taken out.
cleaned under running water and then be
the impeller goes into the socket of the respective bearing.
6. Failures
The pump is designed to have a low maintenance requirement and under normal conditions will be very reliable,
provided it is protected from contamination. If the pump gets noisy, the suction basket and the propeller need
to be cleaned or the impeller and bearings need to be replaced.
7. Warranty
Should any defect in materials or workmanship be found within 24 months of the date of purchase AB Aqua
Medic undertakes to repair, or at our option replace, the defective part free of charge – always provided the
product has been installed correctly, is used for the purpose that was intended by us, is used in accordance with
the operating instructions and is returned to us carriage paid. Proof of Purchase is required by presentation of
the original invoice or receipt indicating the dealer's name, the model number and date of purchase. This
warranty may not apply if any model or production number has been altered, deleted or removed, unauthorised
persons or organisations have executed repairs, modifications or alterations, or damage is caused by accident,
misuse or neglect. Please note that the product is not defective under the terms of this warranty where the
product, or any of its component parts, was not originally designed and / or manufactured for the market in
which it is used. These statements do not affect your statutory rights as a customer.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
3. Power supply
4. 0 - 10 V socket
re-assembled. When assembling, make sure that the ceramic shaft of
- Technical changes reserved – 10/2018
First of all, remove the bottom
It can be
7