Aqua Medic DC Runner 1.2 Mode D'emploi page 6

Fig. 2: DC Runner 2.2 + 3.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure connections
9. Seal for pressure connections
Fig. 3: DC Runner 5.2 + 9.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
Available spare parts: Please refer to www.aqua-medic.de.
The pump may only be operated with
is 1 m / 40 in.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the aquarium, the power
6. EcoDrift Control
plug must be disconnected from the mains. The connection cable and the power plug must not be
changed. If the power cable is damaged, the pump must be scrapped.
4. DC Runner Controller
The included DC Runner
can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press the button „FEED", the
output will stop for 10 minutes.
There is an automatic shut off if there is no water for 2 minutes. Pull the plug and then re-insert it to take the
controller back into operation. Controller, plugs and sockets have to be kept dry.
6
10. Adhesive sleeve D 25
11. Adhesive sleeve D 32
12. Hose connection pressure side
13. Hose connection suction side
14. Union nut pressure side
15. Union nut suction side
16. Filter basket
17. Sealing plug
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure
connections
water. An installation out of water is possible. The max. water depth
Controller is switched between power supply and pump to adjust the output.
9. Adhesive sleeve D 32
10. Hose connection
11. Union nut
12. Filter basket (only DC Runner 5.2)
The power