Orientation Of The Camera - Abus HDCC71510 Manuel Utilisateur

module. Use the hexagon wrench provided to do
this.
To simplify installation, a retaining rope with
eye is provided in the installation adapter to allow
the camera module to be suspended.
Now guide the connecting cable through the
installation adapter and either into the ceiling or
through the side opening.
The connection to the installation cable can be
made inside the installation adapter if required.
Now insert the camera module into the installation adapter. When doing so, ensure that the guide rail
and guide notch of the installation adapter and camera module fit correctly. It is only then that the camera
module is in the correct position.
Now retighten the fixing screws of the camera module.
After orienting the camera module, attach the camera cap and camera dome.
Now fix the camera dome in place.

5.2. Orientation of the camera

The camera module can be oriented in three axes.
The IR range is strongly dependent on the environmental conditions. If the area in the
camera's field of view reflects poorly or if there are no objects within the max. illumination
range, the brightness of the video image at night may be too low. This will result in poor
usability of the video image.
In addition, when installing the camera it must be ensured that no objects are located in close
proximity to the camera's field of view (e.g. roof gutter or wall). These objects can reflect back
the IR light, resulting in circular fading on the video image in the opposite direction to the
object.
1: Tilt
2: Rotation
3: Pivot
26
English
80°
90°
355°