Description And Operation; Warning - Caution - Vortice C 1.5 Notice D'emploi

DESCRIPTION AND OPERATION

Electronic speed regulator for Vortice products.
Not suitable for products with timers, automatic
switches or pull cords.
Convertible for flush mounting with Kit SCB
code 22481).

WARNING - CAUTION

!
Warning:
• Do not use this appliance for purposes other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician
or Vortice*. Do not leave packaging within the
reach of children or infirm persons.
• Certain basic rules must be observed when using
any electrical appliance: a) Never touch appliances
!
Caution:
this symbol indicates precautions that must be taken to avoid damaging the appliance.
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects. If
any faults are found, do not operate the appliance;
contact Vortice* immediately.
• If the appliance malfunctions or develops a fault,
contact Vortice* immediately. Ensure that only
genuine Vortice spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked by Vortice* immediately.
• The appliance must be installed and the fuse
changed if necessary by a professionally qualified
electrician only.
• Ensure that the electrical system to which the
appliance is connected complies with applicable
standards.
*(or an authorised Service Centre if you are outside the UK-Ireland territory)
6
this symbol indicates precautions that must be taken to avoid injury
with wet or damp hands; b) Never touch appliances
while barefoot; c) Never allow children or infirm
persons to operate appliances unattended.
• Store the appliance out of the reach of children
and infirm persons after disconnecting it from the
power supply.
• Do not operate the appliance in the presence of
inflammable substances or vapours (alcohol,
insecticides, pertol etc.).
• Check that the electrical power supply/socket
provides the maximum electrical power required by
the appliance. If this is not the case, arrange for a
qualified electrician to make the necessary
modifications.
• Use a multi-polar switch with minimum contact gaps
of 3 mm to install the appliance.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
cleaning the outside of the appliance, c) if the
appliance is not to be used for any length of time.
• Maximum adjustable load 1.5 A.
Minimum adjustable load 0.2 A.
• Products are fitted with 5X20 T1,6A H 250V fuses.
• This symbol indicates that the operation
must be carried out by a suitably
qualified person.
ENGLISH