Description And Use; Operation And Use Of The Control Unit - Vortice CB LCD W Notice D'emploi Et D'entretien

ENGLISH

1. Description and use

This installation and maintenance manual is to be considered an integral part of the
CB LCD W remove control unit (hereinafter referred to as Remove Control).
The Remote Control has been designed for wall mounting inside its external box
SC EXT B. The Remove Control is equipped with an LCD graphics screen for HRU
Vortice system control (Heat Recovery Unit).
This manual must be stored for future reference until dismantling. It is intended for
specialised installers (installers - maintenance operators) as well as for the end
user. This manual describes the installation modes to be complied with for correct
and safe operation of the equipment and information on how to use and maintain
it.
In case of sale or transfer of the device to another user, the manual must follow the
device to its new destination.
Before installing and/or using the equipment, read this instructions manual
carefully, in particular the "Safety" chapter.
The manual must be stored with the device and remain at the disposal of qualified
installation and maintenance personnel..
Structure and equipment
(Fig. 1)
- (1) No. 1 Plaque
- (2) No. 1 Remote control unit (pre-assembled on support)
- (3) No. 1 SC EXT B wall box (supplied)
- Supplied screws

2. Operation and use of the control unit

The Remote Control user interface allows users to:
- Regulate fan speed
- Modify weekly programming
- View and manage any alarm situations
User interface
Fig. 2
The Remote Control is equipped with a graphics display and some buttons as
shown in the figure.
14