Troubleshooting; Main Specifications - Denon CDR-W1500 Mode D'emploi

19

TROUBLESHOOTING

Check Again Before Assuming The Player Is Malfunctioning
Are all the connections correct ?
2
Are you following the instructions in the manual ?
2
Are the amplifier and speakers operating properly ?
2
If the CDR-W1500 does not seem to be functioning properly, check the table below. If this does not solve the problem, the CDR-
W1500 may be damaged. Turn off the power, unplug the power cord from the power outlet, and contact your store of purchase or
nearest DENON sales office.
Symptom
• Ensure that the POWER button is on.
No power.
• Ensure that the mains cable is plugged in correctly.
• Check if auto track is selected.
• Check if there are 3 seconds silence in between the tracks.
Auto track does not work.
• Check if the source is a consumer source with the digital output according to the IEC
audio standard.
• Check the audio connections.
No sound.
• If using an amplifier, try using a different source.
Amplifier sound is distorted. • Check that the CD recorder analog output is not connected to the amplifier Phono input.
• Ensure that the label of the CD is facing up.
Play will not start.
• Clean the disc.
• Point the remote control directly at the CD recorder.
Remote control does not work.
• Check the batteries and replace if necessary.
• Clean the disc.
• Check if CD-R is an unfinalized disc.
• Check that the disc is recordable and replace if necessary.
• Check whether there is time remaining on the disc.
("Disc Full" is displayed.)
Will not record.
• Check whether there is an attempt to digitally record a digitally recorded source.
("Copy Prohibit" is displayed.)
• Check whether the recording level adjustment is suitable.
• The disc is not an AUDIO disc ("Use Audio CD" is displayed).
• Wrong input source chosen. Input label flashing.
Recording is distorted. • Make sure the recording level is correct.
10 second pause between recordings. • See setting the synchro recording level.
• If then appears on the display, the disc cannot be recorded further, and cannot be
"Disc Error" on the display. finalized. But it can still be played on the CD recorder or another CD recorder. "Disc
Error"
• Finalize the disc.
A recorded CD-R disc cannot be played on • Is playback possible on another CD player? If so, clean the pickup of the player on
another player or CD unit. which the disc could not be played.
• CD-R discs cannot be played on some CD players.
Copying, recording, finalize and editing of • Is the relay mode set to "RELAY" or "MIX"?
CD-R/RW is not possible. Switch to "SINGLE" or "DUAL".
• Is the disc tray for the CD or CD-R section open? Close the disc trays for both the CD
Menu mode cannot be set. and CD-R sections.
Finalizing is not possible. • Is the CD or CD-R section operating? Set the stop mode for both the CD and CD-R
sections.
Check Page
8
7
11
6
–
7
7
7
10
6
9
9
6
–
5
7
6
16
6
8
16
11
–
6, 27
–
–
24
27, 33
27, 33
20

MAIN SPECIFICATIONS

Audio: CD unit:
2
Frequency response: 2 Hz to 20 kHz:
Dynamic range: 98 dB:
S/N ratio: 105 dB:
Harmonic distortion: 0.003 % (1 kHz):
Wow & flutter: Below measurable limits (±0.001 % W. peak)
Usable discs: CDs (12 cm/8 cm)
2
Recorded audio CD-R discs for private use (CD-R unit)
Recorded audio CD-RW discs for private use (CD-R unit)
General:
2
Power supply: AC 120 V, 60 Hz
Power consumption: 29 W
Maximum external dimensions: 434 (width) x 101 (height) x 330 (depth) mm
(including feet, knobs and terminals)
Mass: 5.5 kg
Remote control unit: RC-278
2
Remote control system: Infrared pulse
Power supply: DC 3 V, using two R6P (AA) batteries
Design and specifications are subject to change without notice in the course of product improvement.
CD-R unit (for digital editing)
2 Hz to 20 kHz
88 dB
100 dB
0.01 % (1 kHz)
ENGLISH
35