Operation; Intended Use; Before Starting Work; Batteries And Battery Charging - Oregon Professional Série ST120VX-NA Manuel D'instructions Original

Coupe-bordure 120v
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Intended Use

Use your string trimmer equipped with the
appropriate cutting attachment only for cutting
grass, light brush, and similar material Do not
use it for other purposes, since misuse may
result in personal injury or property damage,
including damage to the machine

Before Starting Work

Read the Original Instruction
Manual for the Battery and
Backpack Battery Carrier carefully
before assembling, operating, or
servicing the product.
• Check the battery, tool, and backpack battery
carrier are in good condition.
• Check for misalignment or bending of moving
parts, breakage of parts, and any other
condition that may affect the power tool's
operation.
• Check that all guarding is in place and in good
condition.
• Check condition of backpack harnesses,
straps, and zippers.
• Make sure the battery cable, plug, and power
socket are not damaged.
To repair or replace any damage or worn
part, contact Oregon or an authorized Oregon
servicing dealer.

Batteries and Battery Charging

• Batteries must be used, stored and charged
within battery use, storage, charging
temperature ranges outlined in the
Specifications section of this manual
• Oregon 120V Professional Series tools are
intended for use only with Oregon 120V
Professional Batteries Read and follow all
instructions provided in the Oregon 120V
Professional Battery Operators Manual
• Oregon 120V Professional Batteries must be
charged only by Oregon 120V Professional
Charger Read and follow all instructions
provided in the Oregon 120V Professional
Charger Operators Manual
String Trimmer Model ST120VX-NA
Operation
Fitting the Backpack
Battery Carrier
WARNING:
Professional Batteries should only be used with
a battery carrier supplied by Oregon. Failure to
use any other carrier or method may result in
injury.
• Insert the Oregon Professional Series Battery
into the Backpack Battery Carrier.
• Insert the plug of the battery cable into the
battery socket—make certain the battery
plug is completely seated into the power
socket of the battery.
• Lift the backpack on your body and fit the
carrier as described in the Oregon Backpack
Battery Carrier Instructions Guide.

Fit the Harness

• Put on shoulder strap.
• Adjust length of strap. The carabiner (1)
should be about a hand's width below
operator's hip.
• Detach harness by pressing down on the
carabiner bar and pull the harness loop (2)
out of the carabiner

Balance the String Trimmer

• Attach carabiner to the harness loop on the
drive tube.
• Loosen the screw (3).
• Adjust harness loop.
• Tighten screw.
The Oregon 120V
1
2
13

Publicité

Table des Matières
loading

Table des Matières