Machine Settings; Water Hardness; Technical Data - Electrolux EDE1074PDW Notice D'utilisation

14 electrolux
1. Unscrew cover above the bulb (this can
be found directly behind the loading
aperture, at the top; refer to "Descrip-
tion of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light

MACHINE SETTINGS

ZOEMER SIGNAL PERMANENT OFF
1. Turn the programme selector to any
programme.
2. Press simultaneously the ANT-IKREUK
(LONG ANTI-CREASE) and ZOEMER
(BUZZER) buttons and hold down for
approx. 5 seconds.
3. The buzzer is by default always off. You
can use ZOEMER button to activate or
deactivate sound but machine does not
memorize your selection.

WATER HARDNESS

Water contains, a variable quantity of lime-
stone and mineral salts of which quantities
vary according to geographical locations
thus varying its conductivity values. Rele-
vant variations of the conductivity of the
water compared to those prefixed by the
factory could slightly influence the residual
humidity of the laundry at the end of the cy-

TECHNICAL DATA

Dimensions (mm)
Max. depth
(with the appliance door open)
Max. width
(with the appliance door open)
Electrical connection
Drum volume
Weight of the appliance
Laundry: max. weight
Type of use
Ambient temperature
cover. Do not operate the dryer when miss-
ing o-ring gasket on door light cover.
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
cle. Your dryer allows you to regulate the
sensitivity of the drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any
programme.
2. Press simultaneously the ZOEMER
(BUZZER) and START/PAUZE (START
PAUSE) buttons and hold down for ap-
prox. 5 seconds. The current setting is
on the display:
tivity <300 micro S/cm,
dium conductivity 300-600 micro S/cm,
S/cm
3. Press the START/PAUZE (START
PAUSE) button sequentially until you
set desired level.
4. To memorize setting press simultane-
ously the ZOEMER (BUZZER) and
START/PAUZE (START PAUSE) but-
tons or turn knob to "O" (OFF) position
Width / Height / Depth
Voltage
Frequency
Fuse
Total power
Min.
Max.
– low conduc-
– high conductivity >600 micro
85 x 60 x 58 cm
1090 mm
950 mm
230 V
50 Hz
16 A
2600 W
108 l
32,5 kg
7 kg
Household
5 °C
35 °C
– me-