Stanley CUBIX Mode D'emploi page 11

bix_GB_STHT77340.indd 11
Set Up
Laser Tool
• Place laser tool on a flat, stable surface.
• If using the auto leveling feature move the pendulum
/ transport lock to the unlocked position. The laser tool
must then be positioned in its upright position on a
surface that is within the specified compensation range.
• The laser tool can be placed in any orientation and be
functional only when the pendulum / transport lock is in
the locked position.
Mounting on Accessories
• Position accessory in a place where it will not be easily
disturbed and near the central location of the area to
be measured.
• Set up the accessory as required. Adjust positioning to
be sure accessory base is near horizontal (within laser
tools compensation range).
• Mount the laser tool to the accessory using the
appropriate fastening method to be used with such
accessory / laser tool combination.
CAUTION:
• Do not leave the laser tool unattended on an
NOTE:
• It is best practice to always support laser tool with
one hand when placing or removing laser tool from an
accessory.
• If positioning over a target, partially tighten the fastener,
align laser tool, and then fully tighten.
accessory without fully tightening the fastening
screw. Failing to do so may lead to the laser tool
falling and sustaining possible damage.
Operation
NOTE:
• See LED Descriptions for indications during operation.
• Before operating the laser tool always be sure to check the
laser tool for accuracy.
• In Manual Mode, Self-Leveling is OFF. The accuracy of the
beam is not guaranteed to be level.
• Laser tool will indicate when it is out of compensation
range. Reference LED Descriptions. Reposition laser tool to
be closer to level.
• When not in use, please be sure to power OFF the laser
tool and place the pendulum lock in the locked position.
Power
• Move to the locked or unlocked position to turn the
laser tool ON.
• To turn the laser tool OFF, move
position
Modes
Self-Leveling (See figures
C
• The pendulum lock on the laser tool needs to be
switched to the unlocked position to enable self-leveling.
• The laser tool can be used with the pendulum lock
in the locked position when it is required to position
the laser tool at various angles to project non-level
straight lines.
Manual Mode (See figures
• The laser tool can be used with the pendulum lock in the
locked position when it is required to position the laser
tool at various angles to project non-level straight lines.
01/07/2013 15:3
to the centre
and )
D
and )
C D
11
STHT77340