Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UK
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning the ice maker, maintain a
distance of 10cm between the appliance and
walls or other objects for ventilation. NEVER
LOCATE NEXT TO OR NEAR A HEAT
SOURCE.
3. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
Operation
Control Panel
Hand button
Ice cube size indicator
Making Ice
Note: Before using for the first
time, clean the water tank, ice
basket and ice basket shelf. Use
the first 3 ice making cycle to
flush out the system. Discard
the water and ice created from
the first 3 cycles.
Each time the appliance is refilled, the first
ice making cycle is used to reduce the water
temperature. This results in uneven ice cube
production which is perfectly normal. You may wish
to discard ice created in the first two production
cycles.
4
T315_ML_A5_v7_20190614.indb 4
1. Lift the access lid and fill the water tank up the
level of the ice basket shelf.
2. Connect the appliance to the power and press
the START button.
3. Press the HAND button repeatedly to scroll
through the ice cube sizes. Stop when the
required size is illuminated.
Note: The ice making cycle
takes between 6-12 minutes,
depending on the size of cube
selected. Larger cubes will take
longer to produce.
4. The appliance will run a startup routine and
then begin ice production.
Note: If the water level is too
low, the Water Low indicator
lights up and the appliance
stops working. Fill the water
tank and the appliance will
restart automatically.
5. When the cubes reach the ice sensor the
appliance will stop production. Production
resumes once ice has been removed.
6. Press the STOP button at any time to halt the
ice making process.
Cleaning, Care &
Maintenance
•
Always switch off and disconnect the power
supply before cleaning.
•
Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
•
A POLAR agent or qualified technician should
carry out repairs if required.
2019/6/14 14:40
Publicité
Table des Matières
