Double Insulation For Safer Operation; Use Of Extension Cord - Metabo HPT CR 13VST Instructions De Sécurité Et Mode D'emploi

English
Confi rm if there are any buried object such as electric
cable within the wall, fl oor or ceiling where you are
going to operate here after.
24. Defi nitions for symbols used on this tool
Operate the power tool at voltages specifi ed on its
nameplate.
V ..................volts
Hz ................hertz
A ..................amperes
n
o ................no load speed
W .................watt
.................Class II Construction
---/min ..........revolutions or reciprocation per minute
.................Alternating current
WARNING
....
injury, user must read instruction manual.
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool, metabo HPT
has adopted a double insulation design. "Double
insulation" means that two physically separated insulation
systems have been used to insulate the electrically
conductive materials connected to the power supply from
the outer frame handled by the operator. Therefore, either
the symbol " " or the words "Double insulation" appear
on the power tool or on the nameplate.
Although this system has no external grounding, you must
still follow the normal electrical safety precautions given in
this Instruction Manual, including not using the power tool
in wet environments.
Ampere rating
More Not more
than than
0 – 6
6 – 10
10 – 12
12 – 16
WARNING
Avoid electrical shock hazard. Never use this tool with a damaged or frayed electrical cord or extension
cord.
Inspect all electrical cords regularly. Never use in or near water or in any environment where electric
shock is possible.
6
– To reduce the risk of
MINIMUM GAGE FOR CORD SETS
0 – 25
(0 – 7.6)
18
18
16
14
To keep the double insulation system eff ective, follow
these precautions:
○ Only metabo HPT AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool, and
only genuine metabo HPT replacement parts should
be installed.
○ Clean the exterior of the power tool only with a soft
cloth moistened with soapy water, and dry thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.

USE OF EXTENSION CORD

Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough
to carry the current your product will draw.
An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. Table shows
the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
Total Length of Cord in Feet (Meter)
26 – 50 51 – 100
(7.9 – 15.2) (15.5 – 30.5)
AWG
16
16
16
12
101 – 150
(30.8 – 45.7)
16 14
14 12
14 12
Not recommended