Metabo HPT CR 13VST Instructions De Sécurité Et Mode D'emploi page 13

(3) Hold the body fi rmly until the saw blade completely
cuts into the material. (Fig. 23, Fig. 24)
CAUTION
○ Avoid plunge cutting for metallic materials. This
can easily damage the blade.
○ Never pull the switch trigger while the tip of the
saw blade is pressed against the material. If you
do so, the blade can easily be damaged when it
collides with the material.
○ Make absolutely sure that you cut slowly
while holding the body fi rmly. If you apply any
unreasonable force to the saw blade during
the cutting operation, the blade can easily be
damaged.
Fig. 23
Fig. 24
6. How to use the Hook
The hook can be used to hang up the unit on the beam
or pipe that the width 40 mm Max. temporarily during
operations (Fig. 25, Fig. 26).
CAUTION
The hook should never be used to hang the unit
on your person.
When using the hook, check to make sure that
the main unit will not slip and fall, or become
unstable by the wind, etc.
Never hang the unit from your belt or trousers as
this could cause accidents.
Hook
English
Fig. 25
Hook
Fig. 26
13