Miele PM 1210 Notice De Montage page 4

Produktgruppe 532
4 von 12
en
Parts required
Quantity Mat. no.
1 09752110
Payment system connection
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist
training, knowledge and experience, and recent related work experience) in accordance with all appropriate
local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in
accordance with all appropriate legal requirements, accident prevention regulations and valid standards. All
regulations of the appropriate utility supply companies and standards relating to safety (not limited to electrical
safety) are to be complied with.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable
measurements must be made to ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire.
Lay the wiring harness as shown, Fig. 1.
Pass the payment system connection cable via the through-feed, Fig. 2, Pos. 1, and connect it to the plug
on the previously laid wiring harness.
Set payment system operation in the machine service mode.
For this set the machine to standby mode.
Press and hold the unlit Start button.
Press the Standby button.
Release the Start button. It should light up.
Immediately press and release the Start button 3 times and at the 3rd time hold it pressed in for at
least 4 s.
The symbol "general fault / warning" flashes.
Activate the finger guard.
Press the two bottom selection buttons as appropriate to advance to service mode point 7.
Press the + and - buttons as appropriate to set option 1.
Press the Standby button to quit the service mode.
en
14.04.2014 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
BSK19 connection. Payment system for PM12.
M.-Nr. 09918920