Velleman HAM202 Mode D'emploi page 9

Caution! Remove the batteries from the devices if they will not be
used for a long time. Old batteries can begin to leak and damage the
device.
Alarm
When the red indicator LED [4] lights up continuously, the batteries
are low. In that case, replace the batteries immediately.
1. Remove the screw from the bottom of the alarm cover and take
off the cover [A].
2. Insert 3 identical 1.5 V AA batteries according to the polarity
markings inside the battery compartment.
When the last battery is inserted, the alarm beeps to indicate
that the batteries are installed correctly.
3. Place the cover back and fix it with the screw.
Caution! Each time you replace the batteries, you must reconnect
the alarm to the remote control.
Remote Control
1. Remove the screws from the back of the remote control and
take off the cover [B].
2. Insert 3 identical LR44 batteries according to the polarity
markings inside the battery compartment.
3. Place the cover back and fix it with the screws.
6.2 Connecting the Alarm and the Remote Control
After inserting batteries, point the remote control to the alarm and
push the ARM button [13] twice. The alarm's LED [4] lights up to
indicate that the connection between alarm and remote control is
established.
To clear a connection between an alarm and a remote control, take
out the batteries from the alarm. The connection is deleted
automatically.
Caution! Each time you replace the batteries, you must reconnect
the alarm to the remote control.
6.3 Installing a microSD Card
Refer to the illustrations on page 5 of this manual.
Note: it is recommended to use a formatted microSD card.
To install/remove a microSD card, proceed as follows:
1. Slide the card slot cover [8] as indicated [C] to unlock it.
2. Lift the cover [D].
V. 02 – 22/05/2014
HAM202
9 ©Velleman nv