Beurer BC 57 Mode D'emploi page 21

• EE_ appears if the measurement could not
be performed properly. Observe the chapter
on error messages/troubleshooting in these
instructions for use and repeat the measure-
ment.
• Now select the desired user memory by
pressing the memory button M. If you do not
select a user memory, the measurement is
stored in the most recently used user memo-
ry. The relevant symbol M1 or M2 appears in
the display.
• Press the Start/Stop Button
the blood pressure monitor. The measurement
is then stored in the selected user memory.
Bluetooth Data Transfer
®
If data transfer is activated, data is
Bluetooth
®
transferred after pressing the Start/Stop but-
ton .
• The symbol flashes on the display.
Bluetooth
®
The blood pressure monitor now attempts to
connect to the app for approx. 30 seconds.
. to switch off
21
• The symbol stops flashing as
Bluetooth
®
soon as a connection is established. All mea-
surement data is automatically transferred to
the app. Once the data has been success-
fully transferred, the device switches off.
• If a connection to the app cannot be estab-
lished after 30 seconds, the
bol goes out and the blood pressure monitor
switches off automatically after 3 minutes.
• If you forget to turn off the device, it will
switch off automatically after a maximum
of 3 minutes. In this case too, the value is
stored in the selected or most recently used
user memory.
• Wait at least 5 minutes before taking another
measurement.
sym-
Bluetooth
®