Christopeit Sport RACER BIKE XL 2000 Notice De Montage Et D'utilisation page 12

Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check roughly that all are there on the base of
the assembly steps.
Please note that a number of parts are connected directly to
the main frame preassembled. In addition, there are several
other individual parts that have been attached to separate
units. This will makes assembly easier and quicker for you.
Assembly time: 30 min.
Step 1:
Attach the stabilizer (4+15) at main frame (16).
1. Attach the front foot (15) with the preassembled transport rollers
(56) to the main frame (16). Do this with the two screws M10x90
(3), washers 10//20 (5) and cap nuts (6).
2. Attach the rear foot (4) to the main frame (16). Do this with the
two screws (3), washers (5) and cap nuts (6).
After assembly has been completed, you can compensate for
minor irregularities in the floor by turning the wheel at rubber feet
(14). The equipment should be set up that the equipment does
not move of its own accord during a training session.
Step 2:
Attach the saddle (13) and saddle support tube (10).
1. Push the saddle support tube (10) into the matching locator in
the main frame (16), set it at the desired position and lock it by
inserting the bolt with the quick release (7) in place and doing it
up tight.
(Note: To screw in the quick release (7), the threaded hole in the
main frame (16) and one of the holes in the saddle support (10)
must be aligned. Furthermore, ensure that the saddle support
(10) is not pulled out of the main frame beyond the marked
maximum adjustment position. The setting of the saddle support
can be adjusted as desired later.) For this, the quick release (7)
must be loosened by only a few revolutions (do not unscrew
completely), the top cap of the lock must be pulled away and
the saddle adjusted. To set the new position, release the top
cap and move the saddle support upwards and downwards until
the rapid-action lock engages. Then secure the new setting by
tightening the quick release.)
2. Place the saddle slide (12) into desired horizontally position at
saddle post (10) and screw it tightly onto the saddle support (6)
by using grip screw (21) and washer (20).
3. Push the saddle (13) with saddle bracket onto the saddle slide
(12) and tight it up in desired incline position with both nuts (find
under the seat).
12