Virax VULCA D63 Manuel D'utilisation page 24

NOTE
The VIRFUS D63
thermostats which disconnect the unit if the temperature
reaches 330 ºC and reconnects it when the temperature
has fallen to 265 ºC.
C) THE WELDING PROCESS
This consists of four steps: heating, assembly, setting
and cooling.
1) Heating
• Using light pressure, insert the tube and the accessory
simultaneously onto the corresponding adapters (tube in
the female adapter, accessory on the male adapter)
Fig 11 Insert the tube
• Maintain the tube and the accessory on the adapters
during the time indicated under HEATING TIME in table
1.
24
is equipped with two safety
Fig 12 Heating tubes
2) Assembly
• Remove the tube and the accessory from the
adapters
Fig 13 Removing the tubes