Measuring; Single Distance Measuring; Selecting Units - PCE TLM 300 Manuel D'utilisation

You can choose the "front" reference permanently by
pressing the REFERENCE - key {A,2} longer. Press
the REFERENCE - key {A, 2} longer another time to
change to "Measuring with tripod". Using a tripod
eliminates shaking when measuring over long
distances. On the back of the instrument is an
industry standard ¼"-threaded hole for use with a
camera tripod mounting screw. For correct measure-
ments the reference needs to be adapted.
Press the REFERENCE - key {A, 2} short to change
back to the "rear" reference.
The selected reference setting is displayed
{C, 4}.

Selecting Units

Press UNITS - key {A, 10} briefly to select desired
unit.
Possible units:
Distance Area
0.000 m
0.00 m
0 mm
0.00 ft
1
0.00 / ft in
32
1
0' 0'' /
32
0.0 in
1
0 / in
32
Stanley TLM 300 1.0.0 gb
Volume
0.000 m² 0.000 m³
0.00 m² 0.00 m³
0.000 m² 0.000 m³
0.00 ft² 0.00 ft³
0.00 ft² 0.00 ft³
0.00 ft² 0.00 ft³
0.00 ft² 0.00 ft³
0.00 ft² 0.00 ft³

Measuring

Single distance measuring

Pressing ON/MEASURING - key {A, 1} turns the laser
on. Aim at the desired target and press ON/MEASU-
RING - key {A, 1} again. The measured distance is
displayed immediately in the chosen unit.
Minimum/maximum measuring
This function allows the user to measure the
minimum or maximum distance from a fixed
measuring point as well as to determine spacing - see
figure {H}. It is commonly used to measure a diagonal
distance (maximum value) or a horizontal distance
(minimum value).
Press and hold ON/MEASURING - key {A, 1} until you
hear a beep, indicating the device is in a continuous
measuring mode. Then slowly sweep the laser back
and forth respectively up and down over the desired
target point - see figure {H} - (e.g. a corner in the
room).
Press ON/MEASURING - key {A, 1} again and the
continuous measurement will be stopped. The values
for maximum and minimum distances are shown in
the display as well as the last measured value in the
main line.
5
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
HR
H
RUS
CZ
Measuring
GR