Operation - PCE TLM 300 Manuel D'utilisation

D
Measure with offset
GB
An offset automatically adds or subtracts a value to/
F
from ALL measurements. With this feature toler-
ances can be taken into consideration e.g. between
I
unfinished and finished dimensions.
Select the menu function OFFSET {C, 19} , confirm
E
with the EQUAL - key {A, 8}. Adjust the OFFSET with
the PLUS - key {A, 7} or the MINUS - key {A, 12}.
P
By holding the keys down, the setting values will
increase/decrease faster. Once you have entered the
NL
proper offset confirm your selection with the
EQUAL - key {A, 8}.
DK
As long as an OFFSET {C, 19} is added/subtracted
S
the symbol is visible on the display.
N
Laser in continuous operation
The laser continuous operation activates the laser
FIN
permanently.
J
Press MENU - key {A, 9} briefly to select desired
LASER setting.
CN
Default setting: LASER continuous operation
OFF.
ROK
Reset
PL
When you select the menu function RESET (RESET
HR
will blink in the display) and press the EQUAL-key
{A, 8} the device will default to factory settings.
H
CAUTION: Any customized presettings as well as
stored values will be deleted.
RUS
CZ

Operation

GR
Operation
Switching On/Off
ON: Press ON - key {A, 1} briefly. The laser is
active. Battery indication is displayed until the
next keystroke.
OFF: Press and hold OFF - key {A, 11}. To maxi-
mize battery life the laser beam will switch off
after 90 seconds of inactivity, the device will
automatically switch off after 3 minutes of
inactivity.
CLEAR key
Pushing the CLEAR - key {A, 11} clears the last entry
or measurement. Within a function (area, volume,
etc.) single measurements can be deleted step by
step and remeasured.
Reference setting
If the positioning bracket is folded out, the device
recognizes the position, adapts the reference and
calculates distances accordingly.
The default reference setting is from the rear of the
instrument. By pressing the REFERENCE - key {A, 2},
the setting can be changed, so that the next
measurement taken will be from the "front" of the in-
strument.
Afterwards the reference setting automatically
defaults back to rear. See picture {G}.
4
Stanley TLM 300 1.0.0 gb