Snapper XD ESXD82ZPS Manuel D'utilisation page 11

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
For complete charging instructions, refer
to the Operator's Manuals for your battery
pack and charger models.
NOTE: To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the lock-out button when
carrying or transporting the tool.
INSTALLING THE BATTERY PACK
See Figure 5
„ Align the tongue of the battery pack with
the cavity.
„ Grasp the pole saw firmly.
„ Push the battery pack into the handle
until the latch locks into place.
„ It should slide into position and "click".
REMOVING THE BATTERY PACK
See Figure 5
„ Press the latch button on the battery
pack down and hold.
„ Grasp the pole saw firmly, and pull the
battery pack out of the handle.
ADDING BAR AND CHAIN LUBRICANT
See Figure 6
Use Bar and Chain Lubricant. It is designed
for chains and chain oilers, and is formulated
to perform over a wide temperature range
with no dilution required.
NOTE: Pole saw comes from the factory
with no bar and chain lubricant added.
Level should also be checked after every
20 minutes of use and refilled as needed.
„ Unscrew and remove the cap from the
oil tank.
„ Pour oil in the tank and monitor the level
on the indicator.
„ Make sure no impurities penetrate the
oil tank when filling.
„ Screw on the oil cap and tighten it.
English (original instructions)
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to
the bar or chain.
NOTE: It is normal for oil to seep from the
saw when not in use. To prevent seepage,
empty the oil tank after each use then run
for one minute. When storing the unit for a
long period of time (three months or longer)
be sure the chain is lightly lubricated; this
will prevent rust on the chain and bar
sprocket.
STARTING AND STOPPING See Figure 7
To start:
„ Press the on/off power button.
„ Depress the
squeeze the switch trigger.
„ Press high speed button to increase
speed depending upon actual working
condition. Two LED's will illuminate
above the high speed button indicating
that the pole saw is in the high speed
setting.
To stop:
„ Release the switch trigger.
„ Press the power button again to turn the
unit off.
NOTE: The unit will power itself down after
being idle for 1 minute.
ADJUSTING THE ANGLE OF POLE SAW
HEAD See Figure 8
„ Pull the angle adjustment handle (a)
down. The angle adjustment lock shaft
(b) will down at the same time.
„ Rotate the power output head (c)
clockwise to adjust the cutting angle.
„ The angle can be adjusted between 0
and 90 degrees.
„ When the angle is well adjusted, release
the angle adjustment handle (a).
„ The angle
directly insert into the angle adjustment
positioning hole (d).
10
lock-out button
adjustment lock
and
shaft