Attaching The Front Handle - Snapper XD ESXD82ZPS Manuel D'utilisation

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
To prevent accidental starting that could
cause serious personal injury, always
remove the battery pack from the product
when assembling parts.
SHAFT ASSEMBLY See Figure 2
The attachment connects to the power
head by means of a coupler device.
„ Set the unit on a flat, level surface.
„ Loosen the knob (a) on the coupler (b).
„ Push in the release button (c) located
on the lower shaft (d). Align the release
button with the positioning hole (e) and
slide the two shafts together. Rotate the
lower shaft until the button locks into
the positioning hole.
„ Tighten the knob securely.
NOTE: If the button does not release com-
pletely in the positioning hole, the shafts
are not locked into place. Slightly rotate
from side to side until the button is locked
into place.

ATTACHING THE FRONT HANDLE

See Figure 3
„ Loosen the four screws (a) in the
handle with a philips screwdriver (not
included) and remove the screws from
the handle.
„ Attach the front handle (b) and lower
clamp (c) on the shaft.
„ Adjust handle up or down, if necessary,
to desired operating position.
„ Tighten the four screws so that the
handle cannot be rotated on the shaft.
English (original instructions)
WARNING
USING THE HARNESS See Figure 4
The machine must always be used
properly hooked to the harness worn
when using extension tube. Frequently
check the efficiency of the quick release
mechanism used to quickly free the
machine from the belts in case of danger.
The webbing must be put on before
connecting the machine to the special
coupling and the belts must be adjusted to
suit the operator's height and stature.
„ The belt (a) must go over the left
shoulder towards the right hip.
„ Fasten the snap hook (b) to the provided
fitting on the extension tube.
OPERATION
Do not allow familiarity with products to
make you careless. Remember that a
careless fraction of a second is sufficient
to inflict serious injury.
Always wear eye protection. Failure to do
so could result in objects being thrown
into your eyes resulting in possible seri-
ous injury.
Never use blades, flailing devices, wire,
or rope on this product. Do not use any
attachments or accessories not recom-
mended by the manufacturer of this
product. The use of attachments or ac-
cessories not recommended can result in
serious personal injury.
9
WARNING
WARNING
WARNING
WARNING