Publicité
Les langues disponibles
Les langues disponibles
Stack Dryer on Washer
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1. Using 2 or more people, lift the dryer and set on top of the
washer. Make sure the stacking kit brackets clear the back of
the washer.
2. Slide the dryer to the front of the washer. Brackets will slide
into place along the back edge of the washer.
To secure the dryer front feet:
3. Remove 3 tabs from each of the 2 foot holder cups.
A
A. Remove 3 tabs
4. Tip the dryer back so that the front feet lift off the washer.
While holding the dryer in the tilted position, place a foot
holder cup on 1 front dryer foot. See the following illustration
for correct position of the foot holder cup.
A
A. This edge should be visible from the front when installed
5. Peel paper to expose adhesive on the bottom of the foot
holder cup.
IMPORTANT: The adhesive will stick on the first attempt, so
be sure the foot holder cup is in the correct position before
setting it on the washer. If moving washer and dryer to a new
location in the future, do not remove the foot holder cups.
They will not stick again once they have been removed.
6. While holding the cup on the dryer foot, set the dryer back
down on top of the washer. The foot holder cup will stick in the
proper location on top of the washer.
7. Repeat for the other front foot.
Complete Installation
1. Check to see that the 2 brackets at the back of the washer are
secure. If they are loose, use the 24 mm wrench to turn the
2 back dryer feet out until the brackets are tight to the back
edge of the washer.
2. Lift the front of the dryer and turn the 2 front dryer feet the
same distance as that of the back dryer feet.
3. Place a level on top of the dryer to check for levelness. Check
levelness first side to side, then front to back.
If the washer and dryer are not level, adjust the dryer feet
again and check for levelness.
3
Publicité
