Maintenance Information - Bradley On-Site S19-921 Manuel D'utilisation

S19-921, S19-921H, S19-921HR
Maintenance
WARNING: Water preservatives protect potable water from bacteria, fungi and algae growth for up
to four months. If a water preservative is not used with this eyewash, it is recommended that the
tank be cleaned weekly or as often as needed. Infection, loss of vision or other serious injury may
result from misuse. DO NOT use expired, cloudy, colored or contaminated solution. DO NOT open
preservative bottle if safety seal is broken. DO NOT save unused solution.
Step 1: Inspect eyewash unit
1. Visually inspect the eyewash unit weekly for cleanliness and proper solution level (per ANSI Standard Z358.1-2004).
2. Activate the eyewash unit each time the solution is replaced to ensure proper operation. If the unit is not working properly,
remove it from the hazard area and contact Bradley Corporation immediately.
• Check the sprayheads' water spray pattern for an even, continuous flow. The sprayheads are attached to the arm with
screws and can be detached from the tray for cleaning or obstruction removal, if necessary, and reattached (use a 9/64"
hex-head Allen wrench to remove and reinstall the sprayheads).
• Check the water supply hose at the basin of the eyewash unit for cracks, leaks or wear.
• Check the entire unit for possible water leakage.
• Check the solution for contamination and replace with fresh solution, if necessary.
Step 2: Clean eyewash unit
1. Carefully remove the eyewash tank from the pedestal and drain the water solution from the tank (dispose of the solution
properly). For ease of draining, the pedestal has a drain hole which will accept a 1/2" I.D. tube at the underside of the hole
(tube supplied by others) (see page 5 for drain hole location).
2. Clean the inside of the tank using warm water and a mild soap product; rinse thoroughly.
3. Refill the eyewash tank following the procedures outlined in Step 2 found on page 4.
• To order additional bottles of potable water preservative, contact your Bradley representative or local distributor and ask
for Bradley On-Site® Refill Kit S19-899 (kit includes bottle of preservative, cap and liners).
4. Reinstall the eyewash tank following the procedure outlined in Step 2 found on page 4.
To operate eyewash unit
1. Begin operation by pulling down the tray. OPTIONAL UNIT WITH HEATER JACKET: pull the front flap down and all the way
out. This action should automatically activate the water spray.
2. Hold eyelids open with thumbs and forefingers. Rotate eyes back and forth to ensure a complete rinse. Allow water to bathe
both eyes simultaneously for a minimum of 15 minutes.
3. Seek medical attention immediately after use.
CAUTION: Do not lean on the eyewash tray when in the opened position. Damage to unit may
result.
6 4/10/09 Bradley Corporation • 215-1546 Rev. E; ECM 09-05-0003
Installation