Nailer Operation - Hitachi Koki NV 83A2 Manuel D'instructions Et De Sécurité

English
<NV50A1•NV65AC>
(1) Press the magazine stopper and open the magazine
cover.
Magazine Cover
(2) <NV50A1>
Adjust the position of the nail holder according to the
nail length.
The nail will not feed smoothly if the nail holder is not
correctly adjusted.
1 Lift the nail holder.
2 Turn the nail holder to align the mark with the
numbers (1-1/4"(32 mm), 1-1/2"(38 mm), 1-3/4"(45
mm), 2"(50 mm) on the magazine cover.
For 1-1/4"(32 mm)
For 1-1/2"(38 mm)
For 1-3/4" and 2"
(45 mm and 50 mm)
Magazine Cover
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the nail holder
correctly, the nail holder may be damaged.
(3) Place the nail coil into the magazine.
Insert the first nail into the magazine opening.
First Nail
Nail
Magazine Stopper
Mark
Nail Holder
Magazine Opening
Magazine
(4) Close the magazine cover.
(5) Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open.
Knob
Nail Guide
(6) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole Guide Slot
FirstNail
Nail Guide
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide
surface.
Otherwise, the nail guide will not close
correctly.
4 Pulling the nails to the right, swing the nail guide
closed.
(7) Lock the knob completery.

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 7).
— 14 —
3
2
4
1
Guide Surface
2
Feeder
DANGER
Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.