Operation - Dustcontrol DC1800 Notice Originale

Operation

DC 1800: Connect the unit to a suitable
power source, note requirements on the ID
plate. If an extension cord is to be used,
only waterproof cords are acceptable.
DC 1800 Autostart:
Connect the sub-
ject electric tool to the electrical outlet on
unit. Set the selector switch to the AUTO
position. The unit will start automatically
when the subject tool is started. For manu-
al start of the unit, set the selector switch
to the MAN position.
The DC 1800 is equipped with a filter
indication lamp that indicates when the
filter needs cleaning or changing. The filter
is genereally cleaned once or twice daily
during normal continuous operation. The
unit must be in operation to perform filter cleaning. Loose
the tube from the suction pipe and press the plastic cage
against the black stop head on the exhaust channel so that
maximum pressure is created in the cyclone.
Open the port on the side o the unit three to six times. This
reverse pulse of air cleans the filter.
The machine can be used both with or without collection
sack.
The collection sack should only be changed after the
cleaning of the filters. The collection sack must be tied off
when it is removed from the container. Use only original
Dustcontrol spare parts. There should not be any fold on
the container border. The tightness make that the sac does
not being sucked.
2014-02-25
When remounting the motor top and the cyclone on
the container the hose inlet should be pointed according
to the picture beside.
For best result:
-Secure that no air is between the bag and the barrel
when you apply the bag.
-Secure that no air is leaking between the bag and the
barrel when you are using the machine.
DC 1800 - 12
Part No 94114-C